HY-TTC 50 is a powerful electronic control solution for off highway industries that is well-suited for the rough conditions in which it is used. It is part of a complete and compatible product family and is protected by a compact, automotive-style housing suited to mobile applications.
Features
All I/Os and interfaces mentioned below are protected against short circuit to GND and BAT+.
CPU Core
- 16/32-bit Infineon XC2287 microcontroller, 80 MHz, 768kB int. Flash, 82kB int. RAM
- 64kbit EEPROM
Interfaces
- 1 x RS-232 and 1 x LIN serial interfaces
- 2 x CAN, 125 kbit/s up to 1 Mbit/s
Outputs
- 8 x digital OUT 2A high-side, PWM, configurable as timer inputs
- 8 x digital OUT 4A high-side, configurable as analog inputs
Inputs
- 8 x analog IN 0 to 5V or 4 to 20mA / 10bit, configured by software alternative use as resistive measurements
- 8 x analog IN 0 to 32V / 10bit, range configurable by SW
- 4 x current feedback, configurable as digital outputs/ lowside 2 A
- 4 x digital IN (4 timer 0.1Hz to 10kHz)
- 8 x digital IN
Other
- Internal: monitoring of board temperature, sensor supply and battery
- 1 x sensor supply 8.5/10.0/14.5 V configurable
- 2 x sensor supply 5V
Software
- Programming: C/C++, CODESYS® 2.3 including support for CANopen®
Specifications
Parameter |
ECU Dimensions | 147.6 x 180.3 x 39.8 |
Dimensions for Minimum Connector Release Clearance | 197.7 x 202.8 x 39.8 |
Weight | 650 g |
Connector | 48 pins |
Operating Temperature | - 40 to +85 °C (full load) - 40 to +105 °C (lim. load) |
Operating Altitude | 0 to 4000 m |
Supply Voltage | 8 to 32 V |
Peak Supply Voltage | 45 Vmax |
Max Idle Current | 0.15 at 9V |
Standby Current | 0.5 mAmax |
Total Load Current | 25 Amax |
Standards |
CE-Mark | 2014/30/EU |
E- Mark | ECE-R10 Rev.4 |
EMC | ISO13766, up to 200 V/m, 20 MHz to 1GHz |
ESD | IEC61000-4-2 |
Load Dump | ISO7637-2, 173 V, 2 Ohm |
Ingress Protection | EN 60529 IP67 ISO 20653 IP6k9k |
Temperature | EN 60068-2-1, -14Nb, -2, -78, -30 |
Vibration, Shock, Bump | IEC 60068-2-29,-64, -27, -32 |
Housing and Connector
- Aluminum pressure die-cast housing
- Water-proof 80-pin connector
- Pressure adjusting with water barrier